VTP too high!! [Archive] - FSDeveloper Community

ras78

22 Sep 2006, 11:51

Hello guys, finally I was been able to drop a VTP ortophoto with SBuilder. Many thanks to all you! But I still have a strange error. My scenery loads correctly but appears as elevated 100km above the surface. Looks the screens attached: in the up view all looks good, but have a look to the other...

What's wrong? May I have to change the VTP layer? under my scenery there's the Norway terramesh and norwegian airports scenery.

thanks!

arno

22 Sep 2006, 15:49

Hi,

Looks like they are not VTP polygons in that case, as these should be placed on the mesh. Are you sure you did not compile the higher resolution polygons as well in SBuilder? If you don't have the proper DEM data loaded these can end up in the wrong places.

ras78

22 Sep 2006, 16:16

Hi Arno,
yes I wrongly marked also the hires checkboxes. Now it works perfectly, thanks! :D