1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Altitude problem!?

Discussion in 'Airport Design Editor' started by sgt_cormier, 9/3/08.

  1. sgt_cormier

    sgt_cormier

    Joined:
    9/3/08
    Messages:
    4
    Country:
    ca-quebec
    I recently downloaded this software to make my own airport. Everyting going well... until I tried my airport. I was under the ground! So I returned to ADE to check it out. The altitude wanted was 668, and the altitude given is 180. I tried to build another airport, but I can't go farther than 180 ft! So, there's a mean to put my airport altitude to 688 ft?

    Thanks in advance and sorry for my english hehe

    David
  2. sgt_cormier

    sgt_cormier

    Joined:
    9/3/08
    Messages:
    4
    Country:
    ca-quebec
    Okay I found how to, sorry for this. Nut I have another question: How I get the trees out of the runway and the taxiways?:confused:
  3. gsnde

    gsnde

    Joined:
    21/3/05
    Messages:
    2,898
    Country:
    germany
    You have to exclude Autogen, David.

    ADE is not yet able to provide this functionality. You can either use Luis Sa's SBuilderX or Paavo's Exclusion Builder for FSX.

    SBuilderX is a very powerful program, while Exclusion Builder only deals with exclusion.

    With one of these programs you define a autogen exclusion polygon covering your airport area.

Share This Page