1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Drag and Drop

Discussion in 'ModelConverterX' started by stevo, 22/1/10.

  1. stevo

    stevo

    Joined:
    12/6/04
    Messages:
    306
    Country:
    unitedkingdom
    Hi Arno

    Would it be possible to add a drag and drop feature so if you already have your mdl folder open you can just drag and drop mdls into the program rather than browsing.

    Stevo ;)
  2. tgibson

    tgibson

    Joined:
    22/9/06
    Messages:
    4,420
    Country:
    us-california
    I assume this is actually for Library Creator XML?
  3. stevo

    stevo

    Joined:
    12/6/04
    Messages:
    306
    Country:
    unitedkingdom
    No its for Model Converter X ;)
  4. arno

    arno Administrator Staff Member FSDevConf team Resource contributor

    Joined:
    28/5/04
    Messages:
    21,300
    Country:
    netherlands
    Hi Stevo,

    Yes, that feature is on my wishlist already. Dropping files on the preview would then result in them being imported.
  5. stevo

    stevo

    Joined:
    12/6/04
    Messages:
    306
    Country:
    unitedkingdom
    Cool :D

    ;)
  6. rhumbaflappy

    rhumbaflappy Moderator Staff Member Resource contributor

    Joined:
    2/6/04
    Messages:
    2,515
    Country:
    us-wisconsin
  7. arno

    arno Administrator Staff Member FSDevConf team Resource contributor

    Joined:
    28/5/04
    Messages:
    21,300
    Country:
    netherlands
    Thanks Dick. I have done drag and drop in other tools (I think it was Library Creator XML), so it should not be too hard to add it.
  8. arno

    arno Administrator Staff Member FSDevConf team Resource contributor

    Joined:
    28/5/04
    Messages:
    21,300
    Country:
    netherlands
    Hi,

    I have added this feature now, it will be in the next development release.

    When you drop multiple files on the first is loaded. But that is similar to the normal behaviour, as multiple file selection is not allowed when importing an object.

Share This Page