• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSXA Ground Polygon disappears too early

mendiola_loyola

mendiola_loyola

Resource contributor
Messages
520
Country
peru
Dear All:

All my ground polygons with the check box "Optimize reference point location" unchecked disappears too early when it is close the the left border of the screen when I turn the plane to right.

If I check the "Optimize reference point location" option the problem is gone.

Do I have to check the "Optimize reference point location" option always.

I'm no checking the option "Group Polygons 500m"

Regards
Alfredo Mendiola Loyola
Lima, Peru
 
Hi,

Sounds like the v2 radius might not be calculated correctly in that case. When you optimise the reference point it is put in the middle of your polygons, since that minimizes the v2 radius and thus the autogen exclusion as well. I would just leave the optimize on, since it is better in general.
 
You must log in or register to reply here.
Back
Top