1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How can I visible chock after Shut Off the Engine.

Discussion in 'Modeling' started by Bambi_007, 28/2/07.

  1. Bambi_007

    Bambi_007

    Joined:
    3/1/07
    Messages:
    755
    Country:
    germany
    Hello All,

    my Question is:
    How can I visible chock block after Shut Off the Engine.
    And How can I unvisible the chock after Start the Engine.

    Can I do this, or must I do This with Animation in GMax and when it is, how can I do This.

    Many many thanks with your help.

    When anyone has a link to a tutorial, I will read and learn.

    I Know to open and close a door to animate, but no knowing over visible/unvisible.
    Last edited: 28/2/07
  2. n4gix

    n4gix Resource contributor

    Joined:
    26/9/06
    Messages:
    9,392
    Country:
    unitedstates
    You really need to specify which version of FS you're working with. The techniques for FS9 and FSX are the same, but the XML code is slightly different.

    In any case, complete code for FS9 is here:

    http://www.aerodynamika.com/cgi-bin/yabb/YaBB.cgi?num=1140575115

    In fact, that reply is contained within an entire FORUM that's nothing less than a repository for "Working and Tested" XML code... ;)
  3. Bambi_007

    Bambi_007

    Joined:
    3/1/07
    Messages:
    755
    Country:
    germany
    n4gix - I'm so sorry to forget this:

    It is for FS9.

    But - I will take a look at the Link from u.

    Thank u very much.

    Kisses for u and you're Faimily for that.

Share This Page