1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

FSX Model does not start engine.

Discussion in 'Other' started by mariomotta, 18/11/09.

  1. mariomotta

    mariomotta

    Joined:
    16/3/07
    Messages:
    49
    Country:
    italy
    hi all,
    a weird thing happens, a model that starts engine perfectly on FS9 does not start in FSX even if i use CTRL+E, auto starter mode.
    I could port all the model, textures, gauges in xml, etc.. working except i cant start the engine.
    The only solution i have found is to start engine with another airplane and then change to my one.
    On air restarting works fine, i suspect that the starter does not runs the engine above the required rpm to start, even if brings it near to 20%, but do not know where put my hands.
    put here aircraft.cfg lines that could be of interest:
    Code:
    [electrical]
    max_battery_voltage = 24.0
    generator_alternator_voltage = 28.0
    max_generator_alternator_amps = 60.0
    
    [fuel]
    Center1=0.000,0.000,0.000,726,0.000
    fuel_type=2
    number_of_tank_selectors=1
    electric_pump=1
    
    [GeneralEngineData]
    engine_type= 1
    Engine.0= 0.000, 0.000, 0.000
    fuel_flow_scalar= 2.000
    min_throttle_limit=-0.25
    
    [TurbineEngineData]
    fuel_flow_gain= 0.005
    inlet_area= 5.110
    rated_N2_rpm=29920.000
    static_thrust= 16755.000
    afterburner_available= 1
    reverser_available= 1
    
    [hydraulic_system]
    electric_pumps=1
    engine_map=1,0,0,0
    normal_pressure=3000
    
    [electrical]
    max_battery_voltage = 24.0
    generator_alternator_voltage = 28.0
    max_generator_alternator_amps = 60.0
    tia
    /mario

Share This Page