1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Resetting the static cfg & pitch in aircraft cfg

Discussion in 'Other' started by abutz, 4/1/12.

  1. abutz

    abutz

    Joined:
    21/11/11
    Messages:
    33
    Country:
    us-texas
    Ok here is my problem. After I make mdl and my model is in the container and I change the static cfg or static pitch in the aircraft cfg nothing happens. The model doesnt change positions on either planes. Any suggestions.
    Modeling in Gmax.
    James Abbott
  2. n4gix

    n4gix Resource contributor

    Joined:
    26/9/06
    Messages:
    9,287
    Country:
    unitedstates
    James, both static cfg and static pitch affect the aircraft ONLY when in Slew Mode.

    The wheel contact points for nose/tail gear, left main gear and right main gear affect the aircraft in normal (non-slew) modes.

    Once the wheel contact points are correctly set, entering Slew Mode should barely change the a/c's position.
  3. abutz

    abutz

    Joined:
    21/11/11
    Messages:
    33
    Country:
    us-texas
    St..CFG

    Thank you Bill.

    James

Share This Page