1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SBuilderX: making a lake

Discussion in 'Ground2k4, SBuilder, SBuilderX' started by José Bourgoignie, 18/3/07.

  1. José Bourgoignie

    José Bourgoignie

    Joined:
    20/4/05
    Messages:
    1,039
    Country:
    belgium
    Hi,

    Tried to make a lake with SFBuilderX for FSX. Finished a lake for FS2004 (see screenie).
    Must I make an extra map for the .bgl ? Because: nothing to find. Or is it the CVX_.....bgl ?
    Or is it to early to do such things ?
    The way of working seems different from making a .bgl-file for FS2004.

    Regards. José.

    [​IMG]
    Last edited: 18/3/07
  2. mikrco

    mikrco

    Joined:
    21/10/06
    Messages:
    85
    Country:
    us-oregon
    I had a similar problem with a lake in Alaska that MS left out. Used SBuilderX to replace the missing lake but it would not show. After try several types of Hydro_Polygons I was finally able to get it to show using:

    "Hydro_Polygons_Default_Perennial" as the type.

    You might try that and see if it works for you. SBuilderX is very limited at this point and hopefully a better version will be forthcoming.

    Hope this helps.

    Attached Files:

  3. José Bourgoignie

    José Bourgoignie

    Joined:
    20/4/05
    Messages:
    1,039
    Country:
    belgium
    Hello,

    Did the configuration you suggested to do and it worked well.

    I have to watch out not to zoom too mach for making the polygon (zoom = 18 to 19 is fine... depending of course of the dimention of the lake).

    Thanks for the help !


    Regards. José. :)

Share This Page