1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Start points

Discussion in 'Airport Design General' started by ccartmel, 8/6/08.

  1. ccartmel

    ccartmel

    Joined:
    17/10/06
    Messages:
    127
    Country:
    unitedkingdom
    Hi all,
    I doubt if this is possible but can you designate separate start points or holds for AI GA traffic. At my home airport (EGGP) GA holds and takes-off from 'G'when 27 is active, a taxiway which joins the runway shortly after the runway 27 start. I tried by only linking the GA apron to this holding point. There is only one start point however and other problems then occur, including getting AI aircraft back to the apron after landing!

    Thanks all.

Share This Page