Fixed. it was a simple problem. I would have to see.
The part name was crucial. the "rotor" at the first was not allowed.
I remembered that I had ever been such a problem. So I did a test and it works.
i have problem with my rpm needle.
i`ve two different codes but the needle doesn`t go.
<Variable>ROTOR RPM PCT:1</Variable>...
I`ve tried with "animation condition" and without.
I`ve tried also "animation trigger" (between and mask).
And i`ve tried a combination with both. The animation start once after loading the fs, never with my frequency
i wanted to test whether I can still implement an animation.
Result: i can't
The animation works once when load the fs. when i set the frequency it doesn't work.
I have tested with FSDS 3 and FSDS 3.51.
Where ist the mistake?
the visible-tag have the right position.
my problem is the code directly :confused:
the animated part is ok and is triggered by a switch in VC.
the problem is at the other parts.
the visiblility is by the keyframe from the animated parts?
can i write a code for this or is this...
new problem. the animation work, but i have a problem with the codes.
i have 4 parts. part 1 is the animated part was triggered by switch.
the other 3 parts have a visible in range. only the first part is visible.