• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

MSFS Autopilot PID reset

Messages
531
Country
france
I think the standard MSFS autopilot is quite good if the PIDs are correctly set for the aircraft, this is what I have experienced. I am currently fine tuning the autoland of my aircraft, it works well, but I have another problem:
When autolanding, the autopilot commands a trim nose up attitude, which is normal. When landed, the trim is nose up, I disengage the A/P and reset the trim around 0 to take off again; fine. Now as soon as I engage a vertical mode (V/S or FLCH), the autopilot first sets the trim where it left it last time it was used. Consequently, after landing I take off again, gently climbing to a pattern altitude, and when I engage the autopilot it suddenly points nose up very high, leading to a stall if I don't stop it :(

My understanding is that the PID used for vertical mode commands the trim position from the last "known" position by the autopilot. If I am right, it means I would have to "reset" the autopilot to make it understand the trim is neutral when I take off again after autoland. I do reset the autopilot by turning off all lateral and vertical modes, this works, but when I engage a vertical mode again, it turns crazy by resetting the trim where it left it last time.

Maybe my understanding is wrong, there maybe another problem here. Any suggestion is greatly welcome.

Thanks,
Eric
 
Top