Hi everybody, I know this is not properly a development issue but I hope to find a solution.
I am working at a new custom autogen for a huge photoreal scenery, beginning from the areas surrounding the airports included.
Therefore, I make some flights now and then to test the scenery, and strangely, I notice the autogen disappears almost completely when I approach a given airport from somewhere else.
If I restart the sim from the same airport, the autogen comes back again.
I have read that it could be a memory issue, related to using a fs9.exe patched for large address awareness to avoid OOMs, so I went back to original fs9.exe but the problem still remains. I have also read about REX causing that.
I use Win7 64 Ultimate with 4 GB on a I5-650 and GTX 560Ti.
Has anybody else reported this strange behaviour with custom autogen? Any suggestion would be greatly appreciated.
Stefano
I am working at a new custom autogen for a huge photoreal scenery, beginning from the areas surrounding the airports included.
Therefore, I make some flights now and then to test the scenery, and strangely, I notice the autogen disappears almost completely when I approach a given airport from somewhere else.
If I restart the sim from the same airport, the autogen comes back again.
I have read that it could be a memory issue, related to using a fs9.exe patched for large address awareness to avoid OOMs, so I went back to original fs9.exe but the problem still remains. I have also read about REX causing that.
I use Win7 64 Ultimate with 4 GB on a I5-650 and GTX 560Ti.
Has anybody else reported this strange behaviour with custom autogen? Any suggestion would be greatly appreciated.
Stefano