- Messages
- 3
- Country
Good afternoon, at the moment I am developing a small airfield for local purposes, there was a problem that the takeoff runway goes underground. AFCAD case in the program in ADE. The elevation of the airport in the programme is the same
as in chart and on different sites, where the elevation of the airport is indicated.
If you make the elevation of the airfield a little higher in the ADE, then the band is in the air.
How can I fix it?
Thank you in advance for your cooperation.
as in chart and on different sites, where the elevation of the airport is indicated.
If you make the elevation of the airfield a little higher in the ADE, then the band is in the air.
How can I fix it?
Thank you in advance for your cooperation.