• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Flatten Polygon Issues

B

Bell417

Messages
14
Country
unitedstates
Hello,
I am working on a small, fictional bush airport in Alaska and I'm having some weird issues. It is located on a hillside so I drew a flatten and exclude polygon around the runway (20ft on either side and 40-50ft on either end). I compiled the .BGL to test it and discovered that for some reason, my polygon was not rectangular, but had a rather large lateral bulge on the downhill side and extended farther than 20ft on the uphill side. It also has small lumps at the four corners of the "rectangle". What is up?
 
Not sure but FSX will try and smooth the terrain between the flatten and the surrounding hill.
 
Is there any way I can lessen the effect? It looks pretty bad right now.

1241320644.jpg


What about the lumps at the corners of the flatten polygon, can I do anything about those?
 
Last edited:
Bell417 said:
Hello,
I am working on a small, fictional bush airport in Alaska and I'm having some weird issues. It is located on a hillside so I drew a flatten and exclude polygon around the runway (20ft on either side and 40-50ft on either end). I compiled the .BGL to test it and discovered that for some reason, my polygon was not rectangular, but had a rather large lateral bulge on the downhill side and extended farther than 20ft on the uphill side. It also has small lumps at the four corners of the "rectangle". What is up?
Click to expand...

When working around hillsides you must use the same technique that FSX uses to draw a poly. The triangles placed properly around the poly smooth the bulges and lumps that occur if you use just a flatten and exclude.



picture provided by George :)
 
That looks good, but I don't know where the hillside is in relation to the triangles in the picture.
 
Bell417 said:
That looks good, but I don't know where the hillside is in relation to the triangles in the picture.
Click to expand...
Run FSX and ADE in windowed mode. Connect ADE to FSX and move the user aircraft to the position of the vertices of the triangle, and read the ground height from the red figures on the top-left of the ADE grid.

 
You must log in or register to reply here.
Back
Top