Gauge Setting?

I have made a lot of changes/additions to the SectionF8 F86 and somehow two gauges have started to show red digital outputs upon the face. How do I reset this to turn the digital readout off?

 
Hello Challenge,


I would think that the ReadMe manual for it would have that information. You might also try writing the Author of the gauges and see what he says.

Usually its a built in trigger (usually) that is activated, like a click zone somewhere.

If the gauges are in XML code, you should be able to open them and edit the gauge code so the gauges no long have that ability, but if you know nothing on gauge code, then thats a bit of a huge task, in which I would again say, ask the Author.


Bill
 
Top