• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

ILS on same frequency - one runway

nickw

nickw

Administrator
Staff member
Messages
704
Country
ireland
Now, take note that this is a passed on question, from the guy doing the ground for some scenery.

He cannot seem to get an ILS on the same frequency for one runway to work in FS2004. Is this a known issue? I noticed that OSS had to offset two different frequencies for the London City scenery.

Both runways also have a glideslope.

Any comments?
 
Last edited:
Do you mean both ends of the runway uses the same ILS frequency. If so, it must be possible in FS2004, Teesside (Durham Tees Valley) Airport uses 108.50 for both ends. And it works in my scenery. :)
 
Yes its a full ILS/DME with glide slope, I am using Afcad,dont know if your using another program, but it should work in Afcad.
 
Thanks Stevo.

I believe that this is a scenegenx issue. Apparently, it is just a manual edit.

Cheers,
 
You must log in or register to reply here.
Back
Top