- Messages
- 84
- Country
I built a combination hanger office complex. The office was constructed by extruding part of the side wall of the hanger. It looks fine in Blender and MCX (see attached photos) but when I placed it in PD3V3, the hanger is fine but the office building is only about a foot tall. According to Blender it is over 8 meters tall.
I guess I could make two buildings and place then side by side, but the single building seems to be more efficient.
Has anyone have run across this before?
I guess I could make two buildings and place then side by side, but the single building seems to be more efficient.
Has anyone have run across this before?