FS2004 problem with AI seaplane traffic

Hi to all :)
following the suggestion (reported on below) of "gadgets" user, I'm re-posting in Aircraft Design area the following, already sent in "AI Flight Planner" section.
We are asking again FOR AN HELP to free us from a problem which, alas, we can not solve the AI traffic (VFR project on Como lake).
Although we posted a first preliminary version, unfortunately after takeoff the aircrafts crash (disappear) against the mountains surrounding the lake.

We would like to make one last attempt by changing/increasing the rateo of climbing. So, In practice we need to make sure that a piston plane, soaring at high level, can soar with more rapidity.
To date, using piston aircraft that need to reach the 5800 Ft for "climb" a mountain .... we see that these crash on the mountain as they come to it still too low (around 4200 Ft): then we would increase the rate of climb in altitude.
And here's the question: how/where do we proceed to change the Aircraft file.cfg and anything else needed, as file.air ?
Thank you in advance for any suggestion that can drive us to the solution.
Aldo

......................................................................................................
It is unlikely a simple change to the aircraft.cfg file will accomplish what you want. It's the .air file you're going to have to tweak. (AirEd will allow you to do that. The trick is knowing what to change and by how much. Unfortunately, there's not much definitive information available on how the topic)
But, this sounds like more than just a tweak. It would seem to be a fundamental change in aircraft performance.
I suggest you re-post in an aircraft design forum.
Don
 

tgibson

Resource contributor
Hi,

I would:

1. Increase the wingspan value.

Test, then:

2. If needed, increase the engine horsepower.

Hope this helps,
 
Top