• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX RPM needle problem

M

MijoBerlin

Messages
106
Country
germany
Hey guys,

i have problem with my rpm needle.
i`ve two different codes but the needle doesn`t go.

code 1:

Code: 
<PartInfo>
    <Name>rotor_rpm_rpm</Name>
    <AnimLength>120</AnimLength>
    <Animation>
      <Parameter>
        <Sim>
          <Variable>ROTOR RPM PCT:1</Variable>
          <Units>percent</Units>
        </Sim>
      </Parameter>
    </Animation>
  </PartInfo>

code 2

Code: 
<PartInfo>
        <Name>rotor_rpm_rpm</Name>
        <AnimLength>120</AnimLength>
        <Animation>
            <Parameter>
                <Code>(A:ROTOR RPM PCT:1,percent)</Code>
            </Parameter>
        </Animation>
    </PartInfo>

Are these codes correct?


greetz
 
(A:ROTOR RPM PCT:1,percent) works fine in a couple of my helos, so your problem must be elsewhere
Roy
 
On the needle part...did you assign intermediate keyframes (required for rotations)? Was the part scaled? If it was you need to reset the scale as that will keep it from animating.
 
Fixed. it was a simple problem. I would have to see.
The part name was crucial. the "rotor" at the first was not allowed.
I remembered that I had ever been such a problem. So I did a test and it works.
 
You must log in or register to reply here.
Back
Top