• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

P3D v5 run scenProc in a batch from a different directory?

Clutch Cargo

Clutch Cargo

Messages
1,374
Country
unitedstates
I run my scenProc scripts in a batch mode using the following file:

10a_Section_161_Stage1_1of5.bat
inside the bat file is several scripts to run:

scenProc B:\CHICO\Section_161\CHICO_X17\Control_Data\CHICO_X17_stage1.spc /run
scenProc B:\CHICO\Section_161\CHICO_X18\Control_Data\CHICO_X18_stage1.spc /run
scenProc B:\CHICO\Section_161\CHICO_X19\Control_Data\CHICO_X19_stage1.spc /run
scenProc B:\CHICO\Section_161\CHICO_X20\Control_Data\CHICO_X20_stage1.spc /run
scenProc B:\CHICO\Section_161\CHICO_X21\Control_Data\CHICO_X21_stage1.spc /run

It works good but I have to have the bat files inside the scenProc folder. And that folder is quickly getting filled up! I would prefer to run from another directory and drive, such as for example:

C:\Flightsim Design\scenPROC 3.1\scenProc B:\Section_84\AZ_AO29_scenPROC_Stage-3_final.spc /run

I've tried a few ways but the bats only run if inside the scenProc folder. Any way to do this?
 
arno

arno

Administrator
Staff member
FSDevConf team
Resource contributor
Messages
31,941
Country
netherlands
If you add a full path to scenproc and a full path to the script, I think it should not matter where your batch file is.
 
=Hollywood=

=Hollywood=

Messages
857
Country
australia
And put quotes around the path in case there are spaces:

"C:\Flightsim Design\scenPROC 3.1\scenProc" "B:\Section_84\AZ_AO29_scenPROC_Stage-3_final.spc" /run
 
You must log in or register to reply here.
Top