• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

MSFS Setting values for MIXTURE_LEAN MIXTURE_RICH TurboProp

Hey all

I have been scratching my head with a turborpop engine trying to find where to enter a value for LEAN and RICH mixture

Essentially I would like

Engine Off (will use Fuel Cut Off) this is fine
Engine Idle (40% fuel mixture)
Engine Rich (100% fuel mixture)

If anybody can point me in direction of idle and rich that would be great

thank you
I have been working on this today. I had the same problem. In the end I used the A:General eng mixture lever position but that is not ideal.

did you find another solution?