• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

ADE Taxiways only appear when zoomed far out

T

tk922

Messages
4
Country
netherlands
Hi all!

I installed a freeware version I found on the web of SBSG Natal airport (https://es-cenarios.blogspot.com/2016/03/cenario-de-sao-goncalo-do-amarante_24.html). It looks quite okay, however half of the airport is not showing and it looks like grass has taken over. When I am in top down mode and zoom out a bit, the whole airport shows correctly. I tried to search a bit for a solution and on this website someone said to a similar post to add a Flatten Polygon with ADE. I tried that, with either the same elevation of the airport as well as an inch below, which still gives me the same result. I also added an exclude later to remove some default buildings, but that one also did not affect the showing of the taxiways.
See my screenshots.

Any help is much appreciated, thanks a lot!!!!!

Regards,
Thomas
 

Attachments

  • ADESBSG.png
    ADESBSG.png
    55.8 KB · Views: 28
  • natalzoomedout.png
    natalzoomedout.png
    1.5 MB · Views: 26
  • natalzoomedin.png
    natalzoomedin.png
    2 MB · Views: 26
tgibson said:
Does your airport polygon have flatten in the tag?
Click to expand...
Hello! Yes I added the following polygon, as shown in my attachment. Unfortunately the results were still the same. The airport elevation is 83,21 meters, I tried both with this exact altitude and 2 inches lower (83,19), with again the same results. Any other idea?
 

Attachments

  • polygon.png
    polygon.png
    12.3 KB · Views: 22
You must log in or register to reply here.
Back
Top