• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 Dial creator

Try this version.

Note that Windows draws thick lines with rounded ends so that 1 pixel position adjustment can be needed.
 

Attachments

  • GaugeFaceV4.1.1.zip
    254.7 KB · Views: 1,077
Hi again,

Figured it out! The key was realizing that you can enter angle numbers greater than 360. So I entered 220 as the Start and 540 as the End and voila! Thanks again for the great program.

attachment.php
 

Attachments

  • gauge_creator_map_problem4.jpg
    gauge_creator_map_problem4.jpg
    86.1 KB · Views: 3,480
PS. Setting 542 as the end angle gave me a 60 tick at the end of the gauge.
 
I had created a special method for years that i improved on for creating analog background textures but this just makes it too simple and plan to use this in the future! Thanks to the creator...:wizard:
 
You must log in or register to reply here.
Back
Top