• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

P3D v5 Converting ground poly - missing lines

MatthiasKNU

MatthiasKNU

Resource contributor
Messages
962
Country
germany
Hello everyone!

First of all: I do not know much about airport design.
But I have the problem that with T2G MMMX I cannot start the sim anymore. I have found out that this is due to the Ground Poly.
So I tried to convert the ground poly for P3Dv4.4 with the GPW (yes, I know, copyright etc., but I'm only doing it for me, I don't distribute it).
That worked too, the sim starts again and the ground polygon is shown to me.

But... I have a problem with the ground marks.
Nearby they are displayed, but flicker.
A little bit further away they are missing completely:
2020-9-21_9-57-5-476pnkyi.png


2020-9-21_9-57-9-396x1jfh.png


I already tried to set the ground poly 1 meter lower, but it didn't help either.
I also converted the bgls with the ground markings for P3Dv4.4. I also tried to convert the ground markings with the GPW, without success.

I'm pretty sure that this is very easy to solve, but I don't know enough about it.
It would be great if someone could help me!

Thanks in advance!
 
You must log in or register to reply here.
Back
Top