- Messages
- 162
- Country
hi all,
a weird thing happens, a model that starts engine perfectly on FS9 does not start in FSX even if i use CTRL+E, auto starter mode.
I could port all the model, textures, gauges in xml, etc.. working except i cant start the engine.
The only solution i have found is to start engine with another airplane and then change to my one.
On air restarting works fine, i suspect that the starter does not runs the engine above the required rpm to start, even if brings it near to 20%, but do not know where put my hands.
put here aircraft.cfg lines that could be of interest:
tia
/mario
a weird thing happens, a model that starts engine perfectly on FS9 does not start in FSX even if i use CTRL+E, auto starter mode.
I could port all the model, textures, gauges in xml, etc.. working except i cant start the engine.
The only solution i have found is to start engine with another airplane and then change to my one.
On air restarting works fine, i suspect that the starter does not runs the engine above the required rpm to start, even if brings it near to 20%, but do not know where put my hands.
put here aircraft.cfg lines that could be of interest:
Code:
[electrical]
max_battery_voltage = 24.0
generator_alternator_voltage = 28.0
max_generator_alternator_amps = 60.0
[fuel]
Center1=0.000,0.000,0.000,726,0.000
fuel_type=2
number_of_tank_selectors=1
electric_pump=1
[GeneralEngineData]
engine_type= 1
Engine.0= 0.000, 0.000, 0.000
fuel_flow_scalar= 2.000
min_throttle_limit=-0.25
[TurbineEngineData]
fuel_flow_gain= 0.005
inlet_area= 5.110
rated_N2_rpm=29920.000
static_thrust= 16755.000
afterburner_available= 1
reverser_available= 1
[hydraulic_system]
electric_pumps=1
engine_map=1,0,0,0
normal_pressure=3000
[electrical]
max_battery_voltage = 24.0
generator_alternator_voltage = 28.0
max_generator_alternator_amps = 60.0/mario