- Messages
- 26
- Country
Hi All,
For anyone who cares, I found the cause behind MakeMDL returning the subject error message. I still don't know the meaning of "count must be positive or zero" but the cause was the texture applied to the stabilizer/elevator. When I applied the texture the first time I noticed that athough I put it on the top surface it also went on the bottom. I ignored that peculiarity and applied it to the bottom again. Today I found that leaving the bottom alone allowed MakeMDL to complete. Apparently no one else has had this problem because I didn't get much response to the original thread, but if you ever do see this error message, be alert for parts that don't take the texture in the normal way. I have read that part texturing can be risky, but I usually get by with it.
Larry
For anyone who cares, I found the cause behind MakeMDL returning the subject error message. I still don't know the meaning of "count must be positive or zero" but the cause was the texture applied to the stabilizer/elevator. When I applied the texture the first time I noticed that athough I put it on the top surface it also went on the bottom. I ignored that peculiarity and applied it to the bottom again. Today I found that leaving the bottom alone allowed MakeMDL to complete. Apparently no one else has had this problem because I didn't get much response to the original thread, but if you ever do see this error message, be alert for parts that don't take the texture in the normal way. I have read that part texturing can be risky, but I usually get by with it.
Larry