• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Multi effects

F

fin10

Messages
8
Country
unitedkingdom
Hi all,

I am again in need of assistance.

I have placed a number of effects (explosions) in my battle ground with a controller set to randomise the effects. All is working well in that the effects goes off, finished, waits a short period of time and then goes off again. The problem is, because I have used this controller and have then placed a number of the same controller into the scenery, they all activate, run through what they have to do and finish at the same time.

How do I configure them to happen at different times?
 
You must log in or register to reply here.
Back
Top