I've been using Simming since the old C64 days, and starting with FS9 I've created a few fictitious airports, with varying degrees of success. But now I've run into a curious problem.
I just finished re-creating Pyote AAF from information gathered from Abandoned & Little-Known Airfields, Google Earth, et al.
Base design was with AFCAD V2.21, excludes, Land class polys, and roads with SBuilder for 2004. No warnings on compilation.
Now - here's the problem - when selecting my saved flight (used during the construction phase), my new (old) Air Base lists in the airport window and shows correctly once the flight loads. But when I try to select it for a fresh flight, or for flight planner purposes, IT'S NOT THERE!!.
I've never had this happen before and am rather puzzled by it.
Any thoughts or suggestions would be greatly appreciated.
I just finished re-creating Pyote AAF from information gathered from Abandoned & Little-Known Airfields, Google Earth, et al.
Base design was with AFCAD V2.21, excludes, Land class polys, and roads with SBuilder for 2004. No warnings on compilation.
Now - here's the problem - when selecting my saved flight (used during the construction phase), my new (old) Air Base lists in the airport window and shows correctly once the flight loads. But when I try to select it for a fresh flight, or for flight planner purposes, IT'S NOT THERE!!.
I've never had this happen before and am rather puzzled by it.
Any thoughts or suggestions would be greatly appreciated.
Last edited:
