Normally my experience with animation is restricted to very simple, single objects, like a sliding door or barrier arm. However I've been playing with a roller door, which I've broken down into sections, each of which slides up and disappears into the wall at the top of my door.
I've used 6 sections, to keep them from sticking out the top of my building -- they just stop when they get to the top, until they are all 'piled up'.
When I start a flight, the sections are all messed up, but if I reload the flight, it works fine. Is there a trick to synchronising the different sections?
Ultimately I'd like this controlled by SODE using proximity, but I'd like to at least understand what is going on here before I even look at SODE
I've used 6 sections, to keep them from sticking out the top of my building -- they just stop when they get to the top, until they are all 'piled up'.
When I start a flight, the sections are all messed up, but if I reload the flight, it works fine. Is there a trick to synchronising the different sections?
Ultimately I'd like this controlled by SODE using proximity, but I'd like to at least understand what is going on here before I even look at SODE