• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 Animation condition then stop.

I have created a set of doors which open at a certain distance from the user aircraft but once the aircraft reaches the required distance and passes through them they close as intended but then the animation starts again. How do I set it to stop until I approach the door again?
Did you use a distance or bounding box trigger?

Normally the animation should only trigger when the trigger distance is passed not continuously.
Hello, sorry for the late response,

I used a distance trigger.I haven't tried the bounding box trigger yet.
CAT is managing to confuse me real good haha.
If you use the distance trigger in the spot view, it's measured from the viewpoint and not from the aircraft. Could that be the problem?