• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 Animation Problem

Messages
292
Country
unitedkingdom
Happy new year everyone.

I hope someone can help, I have a problem with my main gear compression animation, it looks OK in Gmax but in the sim it is not, I have keyframe animated the gear as follows, 100- fully extended, 150- compressed & 200- fully compressed, the problem lies in the compressed position where it does not appear to be compressed enough (See attached picture). I have checked that the pivot points are all set to "local" & not "view". The gear animation for fully extended & full compression looks OK.
 

Attachments

  • Main Gear.png
    Main Gear.png
    153.9 KB · Views: 527
Hello Paul,

You'll need more keyframes than that, I'm afraid, and for two reasons. One is that FSX prefers more (if it's FSX you're modelling for) and the other is that the links' animation is not a constant rate of turn: from fully extended to fully compressed the link arms turn at an increasing rate.

So you'll need more keyframes between 100 and 200. Perhaps every 10 frames? This can be built with animation constraints, but this is not the thread for that!
 
Thank's Tom for your advice.

The model will be primarily for FS9 as I only have the FS9 SDK but I find it easier to check it in FSX.

I increased the keyframes for the compression animation to every 10 frames but it is still the same, there are 8 keyframes for the torque link animation. What I find strange is that the nose gear animation works perfect with only 3 keyframes each for the compression & torque link animations. I'm only a beginner & have no experience of using animation constraints yet!!
 
Okay, have the animation controllers for all your animated objects been set to Linear? That's a must, see this thread from SOH
 
Thank's Tom, I did change the animation controllers to linear but there was no change, so I had a look at some source files I have for reference & looked at the gear animations & the animation controllers are set to Bezier for position & TCB for rotation, so I changed my model animation controllers to these & hey presto the gear animation now works perfectly!!!!

Thank's for pointing me in the right direction & also the extra keyframes were needed as it does not work without these.

Thanks again.
 
Back
Top