• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX autopilot

G

gary24

Messages
4
Country
unitedkingdom
Autopilot:
The problem start a few minute after take-off, It start when you switch on the autopilot.
(the autopilot has been set by reading the manual).
After switch on the AP, the aircraft lose air speed, then stall, then lose altitude.
Then you find yourself going along the gound with no way off take-off and get airborn again.
I had the same problem with FS2004 and FSX gold edition
 
You didn't state what the aircraft was, and based on what little information you have provided I'd say it's pilot error, not 'Flight dynamics'.
 
the one it happen is on concord in 2004 and on
737 pilot in command, 747 in FSx.
if it is pilot error please tell what i am do wrong.
I thank it cound be a bug?
 
Well, it never happens to any aircraft I use... so I'd say it's probably not a bug.

Is this a climb using vertical speed? FLC? Pitch?
 
When I frist had FS2004 and I was flight concorde it was alright (take-off ,climbing and went all the way to New York it went OK), then the problem start.
The set up was the same (flight plan, autopilot and the INS).
I think it a bug from a download add on?
 
No addon changes the default autopilot behavior for all aircraft, it's just not possible.

You didn't actually tell me what autopilot mode you were using to climb with.
 
Sounds to me that you've selected rate of descent instead of rate of climb. Plus your airspeed is probably too low and/or you over rotate. It also sounds as if you have crash detection turned off.
vololiberista
 
You must log in or register to reply here.
Back
Top