• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Bubble Canopy question?

mskhan1991

Resource contributor
Messages
935
Country
pakistan
I want to smooth out my canopy as there are actually two cylinders making up the canopy. Is there any way to smoothly merge the two cylinders as shown in the picture below?

Any tutorial on bubble canopies available?

945931_10151489560971299_1744179947_n.jpg
 
They look fine to me. Would you need to weld or smooth them into each other?


For instance, on the real plane, those surfaces will be sharp edges (around the canopy at the fuselage join section) because of the rail edges of the canopy, etc. Sometimes people want to model hard edges, so they will actually Split the edges making them separate parts so that smoothing does 'not' occur.

But on the rear section, if you wanted to weld them, if they have a real world smoothed chamfer in them, then weld them at the seams, then add in some close proximity Chamfering close to the join weld seam so that the smoothing doesn't get too huge.


This is what I would do and might not be what you want. I also may have misinterpreted what you were asking.



Bill
 
I am looking for this thing in order to elaborate

See how smoothly the canopy merges into the fuselage?
I am trying to do that

jf-17_thunder_zhuhai_2010_01_pilot.jpg


jf-17_thunder_all_round_view_book_cover.jpg


My canopy just goes with a deep edge inside the fuselage
 
Well, the only working approach for parts with complex geometry that I know is trial and error. *Shrugs*

Just push vertices around until it looks satisfactory.
 
Back
Top