• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 Can this River be moved

Dangerousdave26

Dangerousdave26

Messages
42
Country
us-ohio
I am building an airstrip in FS9 that is not in the sim at default but is a real airstrip.

I have run into a small problem. The airstrip is in the mountains in Idaho. FS has chosen to draw the river too far to the north.

I would like to exclude or remove a section of the river so I could create a new scenery bgl that has the river in the proper place.

So far here is what I have.

The BGl file the river is in is ST917150.bgl. Located in the scenery/namw/scenery folder.

I have a screen shot calibrated in SBuilder 205 and the bgl file placed over it.

River_002.jpg


To give you an ideal of how far off it is the center two push pins mark both ends of the runway. The river should be right up on runway 34 and the mountain should be right at the back of RWY 16.

Is there a tutorial out there that can give me detailed instructions on removing this section of the river and then drawing it back in?

Thanks

Dave
 
You must log in or register to reply here.
Back
Top