• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX Creating An Array Issue

Messages
292
Country
unitedkingdom
Hi all,

I am experiencing problems creating an array of a part in Gmax, below is a screenshot of my settings.

Array Settings.PNG


No matter what I do with the settings it just copies the part in the exact same position as the original.

Any help will be much appreciated.

Paul
 
Including values for the movement axis didn't work, however what did work was to enter in the Array Dimentions 1D Count value as 11 & 360 for the incremental Z axis rotation & then I reduced the Array Dimentions 1D Count to 10 which is the number I wanted.

Array.PNG
 
Your original screenshot showed a 360 degree rotation around the pivot for each copy, so Gmax would make a copy and rotate it 360 degrees around the pivot leaving the copy in the same place as the original and repeat this process for the subsequent copies. That's why the copies all finished up in the same place. A 36 degree rotation would do the job you wanted with 9 copies.
 
Thanks, I can see where I went wrong, I entered 360 in the incremental section first & should have emtered it in the totals:banghead:.
 
Hello

Although 3ds max and Gmax are slightly different, perhaps this videos would help you with a method which can be adapted to Gmax:

Video 1:

Video 2:

Hopefully, this might be helpful.
All the best,
Sergio.
 
Thanks Sergio, I think I know what I am doing now, also the Max array interface is very similar to the Gmax one except that there is no preview option.
 
Back
Top