• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Creating even shell thickness

Messages
235
Country
ca-ontario
Presently, I have created the hull of my boat using a flat box 1 1/8" thick for the bottom and modifying the vertex to form the bottom shell and similar for the sides but using a vertical box 3/4" thick.
The problem is that once the shell is formed I don't have a even thickness perpendicular to the surface
I seem to recall reading about creating the outer shell with a thickness of .001 and then "extruding" towards the inside to get the even thickness for the inside shell.
But now I can't seem to find it again and I have been exploring the extrude command with no luck.
Can somebody explain how this is done?

Michel E Paquette
 
Thank you Tom
That looks pretty much like what I am looking for.
The previous 6 lessons also looks like something I should look at for doing my windows later on.


Michel
 
Make sure your model is rescaled before doing Shell. Reset the X-Form and then Scale. (Save before you do this, save one notch up).

Shell is more stable then Extrude/Local.

If your Shell isnt working right, try using Shell just a bit, then 'Scale' the inside to the thickness you need. You can also select sides of your ship with Select By Angle, set angle (preset at 45) to what works for you, then 'move' the sides manually till the thickness is correct, doing this for left, then right, etc.
 
By the way, I learned those techniques in Gmax for 'extruding just a bit' and then using Move to move out sides, top, and bottom seperately, or using 'Scale' one axis at a time for the entire inner area (minus the window openings polygons).
 
Back
Top