-
Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:
- Tag FS2020 specific questions with the MSFS2020 tag.
- Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
- Questions about aircraft design can be posted in the Aircraft design forum
- Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
- Questions about terrain design can be posted in the FS2020 terrain design forum.
- Questions about SimConnect can be posted in the SimConnect forum.
Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.
By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.
MSFS20 Drone camera
- Thread starter GHD
- Start date
Christian Bahr
Resource contributor
- Messages
- 1,142
- Country
In drone mode you switch on the NumPad and then use the numeric keypad to pan the camera.
- Messages
- 12,244
- Country
But not centred on the aircraft.
What is your drone model? Because not all the drones have this possibility. There are a lot of drones, which can only look at one point, if you didn't make any changes/upgrades on your drone. You can read in this article some additional information https://mydronehq.com/can-drones-detected-radar/ about the drones and some features of them, which I am sure a lot of users didn't know about them. You will find there how to make some changes on your drone, so your camera will be watching how you want it to.
Last edited: