• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Error message in gmax

Severin

Severin

Resource contributor
Messages
251
Country
ca-ontario
Hello all, I'm trying to export an object but I'm getting the following message.
Initially converted it to an "editable mesh" and I don't know how to go back to "object mode" for exports.Any help?
 

Attachments

  • Error message.png
    Error message.png
    79.4 KB · Views: 360
Hello,

If you have converted your object to an editable mesh you cannot go back and make it an object again.

The message you get usually appears due to a "wrong" assignment of the decimal (.) and digit grouping symbol (,) in region and language of windows.
Go to control panel-->region and language and confirm that (.) is assigned for decimal and (,) for digit grouping symbol. If they are set in opposite way correct them.

-=Manwlo=-
 
manwlo said:
Hello,

If you have converted your object to an editable mesh you cannot go back and make it an object again.

The message you get usually appears due to a "wrong" assignment of the decimal (.) and digit grouping symbol (,) in region and language of windows.
Go to control panel-->region and language and confirm that (.) is assigned for decimal and (,) for digit grouping symbol. If they are set in opposite way correct them.

-=Manwlo=-
Click to expand...
Okay thank you Manwlo.
 
You must log in or register to reply here.
Back
Top