• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Eyefinity

Messages
64
Country
australia
Discussion on another thread has reminded me of a problem i am having with eyefinity.

My monitors are 2 x 23" (side windows) and 1 x 24" (main window) all are 1920 x 1080 resolution (all running at 60Hz)

Whenever i change my system to run eyefinity in a 3x1 configuration...it cuts down the vertical part of my display so that i lose perhaps 20-30% of the visible vertical display area i had when only running a single monitor. Its as if it is actually scaling both the x and y in order to increase the width of my viewing area instead of locking the x (at 1080) and simply increasing the width of the viewing area (increasing pixels from 1920 to 5760)

What i dont understand is that my system tells me that the display is 1080x5760 but it most certainly doesnt look like it. Even the windows desktop clearly shows the top section of my normal desktop is no longer visible and the desktop icons are all stretched out in both directions!

does anyone know why that happens? Is it because i have 2 x 23" (1920 x 1080) monitors for my side windows and 1 x 24" (1920 x 1080)for main window?
 
Last edited:
Physical size should be transparent to the system... I cannot help you further though. I never had worked with Eyefinity setup.
 
Back
Top