hi everyone, been finishing an A310 for p3dv5 and now i came across a snag , the outer flap on the right wing does not extend along the right wing (like it does in 3ds max) in modelconvertex when i export it from 3ds max, but it extends fine on the left wing both in 3ds max and mcx . i tried resetting it and to reset xform, no solution, how can i fix this?:
-
Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:
- Tag FS2020 specific questions with the MSFS2020 tag.
- Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
- Questions about aircraft design can be posted in the Aircraft design forum
- Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
- Questions about terrain design can be posted in the FS2020 terrain design forum.
- Questions about SimConnect can be posted in the SimConnect forum.
Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.
By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.
flap not extending along wing on A310, help?
- Thread starter A306capt9
- Start date
- Messages
- 662
- Country
Does it work properly in the sim? Sometimes MCX doesn't display animations correctly.
But anyway, make sure you unlink the object before doing a reset Xform on it, otherwise it will acquire the transforms of the parent object.
But anyway, make sure you unlink the object before doing a reset Xform on it, otherwise it will acquire the transforms of the parent object.
valid. i reconnected it to the wingflex, that was the issue