• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Hovering Hardware and Align Tutorial

Messages
10,163
Country
us-arizona
Hey all,

First. I am a detail freak. One of the things I discovered I could do is make tiny screw heads and fasteners that are high detail and paste them (mapped) onto tiny squares (Polygons) and hover them over the plane's mesh and place them where screws and fasteners exist.

I then have brilliant detailed small items on the planes exterior that when doing a zoom in, you see them in full detail. I have a blacked edge around the round objects graphics, and with an adjusted Alpha, they appear round in FS.

One thing that always plagues me is 'adjusting them' one at a time, on one side of the fuselage, perhaps 50 or more of these things. Once done, I simply clone, mirror and move to the opposite side of the fuselage (or wing). But the first time takes a LONG time to do each single Polygon.

So today, I decided to look up Align. I had heard many people talk about it, but never figured it out. I found that there are two Align tools on the top toolbar and found that the first 'Align' was quite difficult. But..... The 'Normal Align' was brilliantly simple!

1. Simply have the part selected that must be aligned with said fuselage
2. Click on the Normal Align
3. Click on the center of the Polygon with the cross hairs 3 times
4. The part then appears to be located in the surface of the fuselage but reversed as you are matching the Normals (Polygons) to each others face.
5. Click Reverse Normal and this flips it back outwards again
6. When done with a row, simply click on them and gently move them outwards of the fuselage a very slight amount so that no 'flickering' of intermixed surfaces occur.



A picture (to me) is worth a thousand words, so Voila!

Than the Lord for such an awesome find.



Bill
 
Last edited:
Back
Top