• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Makemdl question

K

kmahon99

Messages
41
Country
ireland
Hi all,

I've made a poly and finally obtained a copy of the fs2002 makemdl. The only problem is that I'm using FSXplanner to get the airport info and the Lat/Lon I provide is -0.4537499696/-90.2658332884 but makemdl says it will only accept it in this format N47*40.32/E20*19.42. I can't find an option for fsxplanner to display it in that format so what should I do?Also I'm a bit confused on this too, In Lat/Lon format is N(location)/W(location) the same position as S(location)/E(location)?.Thanks Guys.
 
Last edited:
Hi,

MakeMDL will also support coordinates in the decimal format as far as I know. You might have to put the N or S and the E or W in front of it though.
 
You must log in or register to reply here.
Back
Top