• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Manifold objects

D

danchircop

Messages
55
Country
malta
Hi all. First of all I would like to thank CaptX and all those involved in contributing with the development of the tool set. I switched to blender a couple of weeks ago which was quite difficult to do since I've been using Gmax for years however I now simply love it and most probably I will shelve g max forever.
Anyway a few days ago I discovered something in blender where by pressing ctrl+alt+shift+M blender will check if your object is manifold(water tight). It will highlight any vertices or open edges. This feature works only in vertex mode. Don't know if anyone knew about it, if not you can consider it as a little tip.

Regards
Daniel
 
Ok, thanks for the heads up! Didn't know about it, also I was not essentially searching for it, but I think I can use it anyway. ;)
 
danchircop said:
Hi all. First of all I would like to thank CaptX and all those involved in contributing with the development of the tool set. I switched to blender a couple of weeks ago which was quite difficult to do since I've been using Gmax for years however I now simply love it and most probably I will shelve g max forever.
Anyway a few days ago I discovered something in blender where by pressing ctrl+alt+shift+M blender will check if your object is manifold(water tight). It will highlight any vertices or open edges. This feature works only in vertex mode. Don't know if anyone knew about it, if not you can consider it as a little tip.

Regards
Daniel
Click to expand...

Hi Danchircop!

Cool, I did not know about that function.

Thank you very much!!!!:D

Kris:)
 
You must log in or register to reply here.
Back
Top