• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Mapping THIS thing!

When I group parts, I keep them is a reasonable boxed area. So maybe like just the panel area, then the engine area or gear. This keeps everything organized and prevents errors. But if you group parts far away then i think you get this issue you guys are taking about.

I might be wrong what i quoted before. I said i had not seen OBED since FS2004. I think it's FSX that only gives this message. Or maybe both game packs.

So i find no problems when using my technique and find it's faster with my shortcuts.

I too compile or attach parts to cut down grouping. usually toward the end.

DG
 
Last edited:
Hi,

Whatever works for you is fine, of course. But don't tell us we didn't warn you. :)
 
Just to be clear here, it's never the "Grouping" that causes the problem.

If you never "Ungroup" then you will never risk the error!

It only (occasionally) occurs whenever you "Ungroup" for any reason.

As long as you "Group" then use Group Open/Close to make changes, it is a safe process!
 
Back
Top