• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSXA Modeling seats

euroastar350

Resource contributor
Messages
863
Country
us-delaware
Hi guys,

I am looking at remodeling the seats in my Bell 222, but don't know what is the best way to approach this. Can someone point me in the right direction or have any source files in Max 9 format they are willing to share? Here is a shot of the seats I want to model. Thanks guys.
100_0185.jpg
 
What you can do is make a very basic rough version of them, super low poly count, then add 1 iteration of TurboMesh and see how they look. This is the route that the pro's go. Very basic sub model, and keep checking it in TurboSmooth to see how its going.

The piping on the seats can be done SUPER EASY. Select the 'Edge' along the area the piping goes. Selected, you then select 'Create Shape from Selection', then set that part as visible via 'Enable in Viewport', give it a diameter and setup its mesh with Iterations so its a cylinder. Get all of its settings just right and then save as a Poly object. Before you do though, tick on the 'Generate Mapping Coordinates.'

Next, when you have mapped the seats, add the piping to the material and check your pre-done Mapping Coordinates. They should be flat and you need only scale and fit them into your texture sheet and give it color. Done! I love doing piping. Adds so much realism to the seats and interiors.
 
United Express has it. Thats exactly what I was talking about. Basic model, sculpt it a bit, then add TurboSmooth. But dont use TurboSmooth and collapse it immediately, keep working with the basic shape till you like it, 'then' collapse to a Editable Poly.

Also, you can begin by doing a side view and use a basic Spline line and do the side profile shape. Then copy another and connect (Attach) then add Cross Section, then Surface, 0.0 on the tension, collapse to a Editable Poly, then extrude sideways a few times, then work with the shape, apply TurboSmooth for checking, and finish when it looks right.

By doing a side profile Spline shape, you are already there with the front surface. Then to just add some wrinkledge (if needed) and those odd indentions, and you are done.
 
Back
Top