• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

multi-frequency for controling an object?

A

Alaa_Qassim

Messages
28
Country
us-texas
Hii!!

i have a question about using multi frequencsies to control an object. so is that posible to make an object become visible for example on 111.00 nav2 frq and 115.00 on nav2 too? if its posible then how to do it using asm tweeking (im using fs2004).

my best regards
 
Last edited:
Yes, that is possible. Normally your condition would be like this:

Code: 
IFIN1 no_object, 07C2h, 1100h, 1100h
; your object code
no_object label word

To show on two frequencies the code would become:

Code: 
IFIN1 check2, 07C2h, 1100h, 1100h
BGL_JUMP show_object
check2 label word
IFIN1 no_object, 07C2h, 1500h, 1500h
show_object label word
; your object code
no_object label word
 
Thank you very much!!:)

but i have a problem with compile it with the second code.
so whats is the problem with that code which make it not compile. (my asm in the attachments)

My regards
 

Attachments

My fault, it is BGL_JUMP_32 instead of BGL_JUMP. Then it should work.
 
You must log in or register to reply here.
Back
Top