• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

MSFS20 Painted Line Lighting

D

DaleRFU

Messages
39
Country
england
Good afternoon all,

I am a little stumped when it comes to using painted lines, more specifically painted lines with lights. In the image below I have two lines in question (the left edge line with lights on the right hand side of the line (drawn near to far), and the line in the middle (which is also an edge line with lights down the right hand side (drawn far to near). How do I change it so that the lights are positioned on the left hand side of a line if I want to? I can't seem to find an option for it.

Kind Regards,
Dale
Desktop Screenshot 2024.01.02 - 13.53.25.65.png
 
Weird that I should stumble across this as I've been having the same query. I've found through trial and error that if you're painting an edge line for a taxiway that is lighted, try starting off the line going round a corner, I've found that once you put the line through 180 degrees past the original point, the lights suddenly switch to the other side. Try and place the points in the opposite order to what you did this time. E.g Right to Left as opposed to Left to Right.
 
You must log in or register to reply here.
Back
Top