• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX parameter SDK FSDS 3.5.1

C

Craken

Messages
28
Country
france
Hello everyone,

Is someone could tell me how a parameter FS Design Studio 3.5.1 with XTo Mdl with MakeMdl because there is no problem but I have XTomdl each time a message telling me to return to the PREFERENCE menu and what I do it does not change anything.
Thank you for your light.
Craken
 
The translation of your post is a little hard to follow but I think you need to go to preference and set FSDS to compile for FSX.

Here are a few screen shots of my set up. Yours will likely be a little different depending on were you have FSDS installed but hopefully this will help guide you.

H_Farfy:D
 
Last edited:
Thank you Farfy,

J have that right, but when I compile with XTomdl, and I do the transfer in FSX, well it is simple fsx not display my model.
Is what you would have an idea of ​​why it do that?
As you also have FSDS 3.5.1, I do not quite understand the procedure leads to a room.
Example I have runs a flap, with key animation l_flap_percent_key called and the result is that my flap disappeared in FSX, I have done with the animation al report example in the book abacus 4, and I do not understand why it gives will result.
After that I understood in FSX for an animation is correct and taken into account by FSX must absolutely be a relative parent part.
Before I worked on Fs Design Studio V3.0 for FS9 and I did not meet much trouble. Would you have advice to give me?
I have another question, I want a key animation to give a room a specific flight on this piece to the role of spoiler, but its specificity is that it is nothing else that is making the shift only if I called the room L_spoiler engages when I go the speed brake, then it should not do.
How can I do?

Thank Farfy for the help you can give me.
 
ModelConverterX (from Arno Geretsen) is a very usefull tool to test MDLs quickly. Think about it next time!
 
Hello Farfy and Jean Pierre

I t Farfy email sending my FSC folder, you will find probably to or from the animation problem.
Jean Pierre I download ModelconverterX for the moment I do not see what it was used but I saw on the forum there is a section ModelconverterX I'll take a look.
Anyway thank you for your help.

Greg
 
You must log in or register to reply here.
Back
Top