• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Problem with ag_tree_lib12

S

sk699

Messages
66
Country
estonia
Hello guys
I ran up to a small problem with ag_tree_lib
I can't get the trees to show up in FS, only a very thin line about 6 m high and few cm wide
I did this: placed ag_tree_lib12 to the scenery folder, then added ag_tree_lib in obplacer, chose the right tree type and started making them. After that i compiled the bgl.
Is that correct? May the exclude for the ground be the problem?
 
They need to be placed to a heading of 0° to work. If you use another heading they won't be visible.
 
Another issue:
I noticed there are some "green lines" above the placed trees
Is it a bug ? If yes then how can i avoid it?
 
You are probably seeing part of the other trees in the same texture. Are you sure that you have the texture detail setup so that the highest mipmap levels are actually shown?
 
Sorry to say but I do not get exactly what you are saying..
If you mean in FS settings, then yes, I have sliders set from high to max
 
I mainly meant the global texture size slider. It is on the hardware tab if I remember correct. If this one is set too low, you will not see the highest mipmaps.
 
Checked it out
MAX global texture won'´t take it away
But here is a picture of it:
 

Attachments

  • Scrshot1.jpg
    Scrshot1.jpg
    4.9 KB · Views: 699
Yes, that indeed looks like the bottom part of the next tree in the texture sheet. Which tree are you placing, then I can check if I see it here as well?
 
I tried it on my PC, but I don't see the problem.

Are you using the default MS tree textures or maybe some sort of replacement texture for them?
 
OK, I guess that is the problem then. This reduced version will have some pixels slightly different of course due to the resizing. And as a result of the that the mapping of the trees is no longer correct.

When I work on an update of the trees, I'll try to make the mapping so that it is also correct with such textures. But for now there is nothing to do about this.
 
You must log in or register to reply here.
Back
Top