• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

send_key_event FAILURE

SkyLu

SkyLu

Messages
74
Country
flag
Is it possible to send failure evets to radio com and nav?
I only found this:
Code: 
KEY_TOGGLE_VACUUM_FAILURE 
KEY_TOGGLE_ELECTRICAL_FAILURE 
KEY_TOGGLE_PITOT_BLOCKAGE 
KEY_TOGGLE_STATIC_PORT_BLOCKAGE
KEY_TOGGLE_HYDRAULIC_FAILURE 
KEY_TOGGLE_TOTAL_BRAKE_FAILURE 
KEY_TOGGLE_LEFT_BRAKE_FAILURE 
KEY_TOGGLE_RIGHT_BRAKE_FAILURE 
KEY_TOGGLE_ENGINE1_FAILURE
KEY_TOGGLE_ENGINE2_FAILURE 
KEY_TOGGLE_ENGINE3_FAILURE 
KEY_TOGGLE_ENGINE4_FAILURE

Thank you
 
You can set the various "partial panel" variables with SimConnect.
I would be tempted to give that a try.

Doug
 
How about this:

Create a "Failure" L:Var, and require the L:Var to be a certain state for the radio section to work. Then, create a button that changes the state of the L:Var when you click it. I'm an XML beginner, so there's probably a better way, but may as well try this one.
 
You must log in or register to reply here.
Back
Top